Filter
Top Products
Wireless Receiver
10
Installing the Camera
To install the camera:
1. Use the included mounting screws to
mount the stand to the mounting
surface:
• Mark the position of the screw holes
on the wall.
• Drill holes and insert the drywall
plugs as needed.
• Firmly attach the stand to the wall
using the provided screws.
2. Slide the sunshade on the camera
body.
3. Screw on the antenna to the back of
the camera.
4. Attach the camera to the mounting
stand. Tighten the thumbscrews to
secure the camera to the stand.
Adjust the angle of the camera until
the desired view is set.
5. Connect the black power cable from
the camera to the cable of the Power
Adapter; plug the Power Adapter to
an outlet or surge protector.
Note: You can install additional
cameras (maximum of 4 cameras).
When adding cameras that were not
included in the original box, you will
need to pair up the cameras with the
receiver. Refer to the camera pairing
section of this manual for more details.
Figure 2.1 Attach the camera to the stand
Figure 2.0 Attach stand to mounting surface