Setting Dwell Time
15
Setting Dwell Time
You can set the length of time (in seconds) that the receiver displays channels while in Auto
Scan.
To set dwell time:
1. Make sure the Wireless Receiver and
cameras are fully connected and powered
on.
2. Press and hold the VGA/QVGA button
and Pair button at the same until the
Dwell Time screen appears. Continue
holding both buttons.
3. With the Pair button and VGA/QVGA
button held down, the receiver will
automatically cycle the dwell time from
1~20 seconds. The higher the dwell time,
the longer each channel remains on-
screen during Auto-Scan.
4. Release both buttons to set the desired
dwell time.
Note: If you repeat this process, the Dwell
Time screen will display the last set dwell
time.
Figure 7.0 Press and hold the VGA/QVGA
and Pair buttons at the same time
Figure 7.1 Continue holding both buttons to
set the dwell time for Auto Scan