Filter
Top Products
8
OPERATION (Continued)
SETUP MENU
The Setup menu lets you customize this digital frame by allowing you to
set the effects between your photos, adjust the speed of the slideshow
and more!
Use the following instructions to navigate and change the options which
are described on the following page.
1. Connect the unit to anAC
power source (as shown
on page 4). In the main
menu, select Setup using
the Navigation Left/Skip
(o) 1 and/or Right/Skip
(n) 2 button; then press
the Select/Play/Pause
(®p) button 3 to enter
the Setup menu.
2. Use the Navigation Up/
Rotate 4 and/or Down/Brightness 5 to select one of the Setup
options (i.e. “Interval Time”), then press the Select/Play/Pause (®p)
button 3or Navigation Right/Skip (n) button 2 to select it; the Setup
option will change to gray from yellow.
3. Use the Navigation Up/Rotate 4 and/or Down/Brightness 5 to
change the desired option setting (i.e. choose between 5 Sec., 15
Sec., etc.), then press the Select/Play/Pause (®p) button 3 to make
the change.
4. Press the Navigation Left/Skip (o) button 1 to go back to the
previous Setup option. Exit by pressing the MODE/Stop (■) button 6.
(NOTE: You can also exit by selecting the Exit Setup Mode option.)
1
3
2
6
4
5
CONTINUED ON THE NEXT PAGE