Microsoft 9.21 Photo Scanner User Manual


 
47
Pre-Pick
It specifies whether a document is picked and carried in front of the scanning position
before starting scanning operation at the ADF scanning.
This function cannot be used when [Double-page spread], [Clipping (Front)] or [Clipping
(Duplex)] is selected. (V9.21, V10.20)
Disable
Pre-Pick is not performed.
A document is picked and carried in front of the scanning position, after starting
scanning operation.
Enable
Pre-Pick is performed.
A document is picked and carried in front of the scanning position, before starting
scanning operation.
Panel setting
The setting of device is followed.
* When selecting “Enable,” you can scan faster than when selecting “Disable,” because of
Pre-Pick process.
When selecting “Enable,” if you cancel during the ADF scanning, a document remains in
the scanner in the Pre-Pick status.
Check Over-skew
The skew of the transmitted document is supervised during the ADF scanning.
When an over-skew is detected, the scanner is stopped and an error message is displayed.
* The image data of the skewed document is deleted.
* This functions, only when “Multifeed Detection” is enabled.
* Skew Detection is a function used for detecting over-skew to stop feeding skewed
documents. If sheets of paper are stapled together, miss-detection may occur.
* Some scanner models do not support this function. See "Relevant Image Scanner
Specification" in Appendix.)
Paper Protection
Marking this check box raises the paper jam detection level to reduce paper wrinkled or
ripped during ADF scanning.
If this function is enabled, paper jam error occurs more frequently than usual.
Disable this function if paper jam error often occurs at paper feeding.
This function cannot be used when [Double-page spread], [Clipping (Front)] or [Clipping
(Duplex)] is selected. (V9.21, V10.20)