Filter
Top Products
5554
3. Press the + or – button to select
for one flash, and for
another.
• The flash set to provides 1/3 of the
whole light intensity. flash provides
2/3 of the whole intensity.
• Do not set both flashes to the same ratio.
Proper exposure may not be obtained.
4. Press the select button.
Using with 3600HS (D) or 3500xi
Set up the 5600HS (D) with the wireless ratio off-camera flash in the
same way as described in 1~4 on page 53~54, and select .
Set up the 3600HS (D) or 3500xi with the wireless off-camera flash.
(See flash or Wireless Remote Flash Controller manual for details.)
Ratio is set to automatically, and provides 2/3 of the whole
light intensity.
Taking Photos
Refer to the Wireless Remote Flash Controller manual.
• Set shutter speed to 1/30 of a second or less (low shutter speed).
2. Press the select button to blink
[RATIO].
CONNECTING CAMERA AND FLASH BY CABLE
The use of the optional off-camera
cables allows photography with the
flash units separated from the camera.
Up to four flash units can be connect-
ed. The ability to take photographs
without the need to consider position-
ing of the flash units provides for con-
siderable freedom to create a variety
of shadow effects on the subject.
• Flash units with accessory terminals
can be connected directly. When con-
necting the 5600HS (D), remove the
terminal cap and plug the cable into
the accessory terminal.
Continued on next page
WIRELESS/REMOTE FLASH MODE
Flash Units
Use the following flash units for off-camera flash photography by
cable.
A group: 5600HS (D), 5400HS, 5400xi, 5200i
B group: 3600HS (D), 3500xi, 2000xi, 3200i, 2000i
• In this mode, ADI metering and pre-flash metering will be canceled
and TTL flash metering will be used automatically.
CONNECTING BY CABLE