Filter
Top Products
REMOTE-CONTROL (optional)
59
CONTINUOUS-DRIVE MODE
58
1. Press the drive-mode
button until appears
in the data panel.
In this mode, the camera continues to release the shutter and
advance the film as long as the shutter-release button is held
down.
2. Press the shutter-release
button down and hold.
• When taking flash pictures, the shutter will release after the
flash is charged.
• When the subject is moving, the shutter will release after the
camera focuses on the subject.
• To cancel continuous-drive mode, press the continuous-drive
mode button until the drive-mode indicator disappears from the
data panel, or turn the camera off.
1. Place the camera on a
tripod, then press the
remote-control button
until appears in the
data panel.
The IR Remote Control RC-3 is an optional accessory you
can purchase to operate your camera from up to 6 m (19.7ft.)
away.
2. Arrange the camera and
subject positions, then
compose your picture.
3. Point the emitter window
toward the front of the
camera and press the • or
2s button.
• If the • button is pressed, the lamp on the front of the camera
will blink once before the picture is taken.
• If the 2s button is pressed, the lamp on the front of the camera
will blink for two seconds before the shutter releases.
Emitter window
2s delay button
Release button
2102 OM E 16/10/97 11:29 AM Page 58