Filter
Top Products
Chapter 4 Programming with NI-IMAQ for 1394 VIs
© National Instruments Corporation 4-5 NI-IMAQ for IEEE-1394 Cameras User Manual
NI-IMAQ for 1394 Acquisition Types
Three NI-IMAQimage acquisitiontypes areavailable inLabVIEW—snap,
grab, and sequence. The following sections describe each acquisition type
and give examples.
Snap
A snap acquires a single image into a memory buffer. Use this acquisition
mode to acquirea single frame or fieldto a buffer. Whenyou invoke a snap,
it initializes the device and acquires the next incoming video frame to a
buffer. Use a snap for low-speed or single-capture applications.
Use the IMAQ1394 Snap VI for snap applications. Figure 4-4 shows a
simplified block diagram for using IMAQ1394 Snap.
Figure 4-4. Acquiring an Image Using Snap
Grab
A grab is a continuous, high-speed acquisition of data to a single buffer in
host memory. This function performs an acquisition that loops continually
on one buffer. You can get a copy of the acquisition buffer by grabbing a
copy to a LabVIEW image buffer.
YoumustusetwoVIs—IMAQ1394 Grab Setup and IMAQ1394 Grab
Acquire—for a grab acquisition in LabVIEW. IMAQ1394 Grab Setup,
which you call only once, initializes the acquisition and starts capturing the
image to an internal software buffer. IMAQ1394 Grab Acquire,which
you cancall multiple times, copies theimage currently storedin the internal
buffer to a LabVIEW image buffer. After the program finishes copying
images, call IMAQ1394 Close once to shut down the acquisition.