Filter
Top Products
NS380 / NS380W User Guide 9
YML826 Rev1 - Pan/Tilt Internet Camera
Rear Panel
1. Network Cable Connector
The Pan/Tilt Internet Camera’s rear panel features an RJ-45 connector for connections
to 10Base-T Ethernet cabling or 100Base-TX Fast Ethernet cabling (which should
be Category 5 twisted-pair cable). The port supports the N-Way protocol and “Auto-
MDIX” function, allowing the Pan/Tilt Internet Camera to automatically detect or
negotiate the transmission speed of the network.
2. External Antenna (for NS380W only)
The rotatable external antenna allows you to adjust its position to obtain the maximum
signal.
3. Reset Button
Reset will be initiated when the reset button is pressed once, and Power LED begins to
flash.
Factory Reset will be initiated when the reset button is pressed continuously for three
seconds or when Power LED begins to light up. Release the reset button and the Power
LED will begin to flash, indicating the Pan/Tilt Internet Camera is changing to factory
reset. When factory reset is completed, the Pan/Tilt Internet Camera will be set to
default on channel 11 and SSID is set as “NULL String” (This default setting will let the
Pan/Tilt Internet Camera connect to ANY access point on the infrastructure network).
The IP address will also return to the default setting as 192.168.0.20.
4. DC Power Connector
The DC power input connector is located on the Pan/Tilt Internet Camera’s rear panel,
and is labelled DC5V with a single jack socket to supply power to the Pan/Tilt Internet
Camera. Power will be generated when the power supply is connected to a wall outlet.