Filter
Top Products
Be sure that all water has been removed .
..
Several days are required for all water to dry from below the rubber cover.
Keep
in
mind that water may still remain
in
hard-to-reach areas even after
the surface has dried.
Disconnect the sync cord from the
socket and attach the cap . . .
Salt and other foreign matter will remain
on
the sync cord and the socket if the cord
is
not disconnected. After washing and drying
the Speedlight, remove the plug and
remove all the salt. After that, it
is
a good
idea to apply a small amount of O-ring
lubricant to the screw threads.
Be
sure
always to attach the socket cap to prevent
water or dirt from getting into the socket.
Also dry the battery chamber . . .
After drying the main body, open the
battery chamber,
remove the battery, and
let the inside of the chamber dry
completely before closing it again.
If switch or selector movements become
rough . . .
Tiny particles of sand getting inside the
panel may affect smooth operation of the
power switch or selector.
In
this event,
remove the four screws (as illustrated),
open the panel, and rinse out the sand.
Reassemble the panel after letting the
inside dry completely. If a screw
is
lost,
use a spare screw provided.
35