Filter
Top Products
Synchro
Socket
®
To
connect the sync cord
@)
to the speedlight, remove
the synchro socket cover
® by turning
it
counterclock-
wise and pulling
it
up. Remove the dust-proof plastic
cap from the sync cord's speedlight plug
@ (black).
Insert the speedlight plug into the synchro socket after
aligning the synchro socket index
CD
with the
red
index
on
the speedlight plug. When the speedlight plug is
inserted, turn its locking
ring
clockwise
as
far
as
it
will
go to secure the plug.
Never submerge the speedlight
in
water with the
synchro socket cover removed
or
get the sync cord
plugs wet. Always make sure either the synchro socket
cover or the sync cord plugs are securely attached
before entering the water.
After shooting underwater, wipe off any water droplets
with a soft cloth before removing the plug to prevent
water from entering the socket. Whenever the sync
Sensor
Socket
(])
To
connect the sensor cord to the speedlight for
non-
TTL
automatic flash control, remove the sensor socket
cover @ by turning
it
counterclockwise
and
pulling
it
up
.
Remove the dust-proof plastic cap from the
sen
sor
cord's speedlight plug (black). Insert the speedlight
plug into the sensor socket after aligning the sensor
socket index
@ with the
red
index
on
the speedlight
plug. When the speedlight plug
is
inserted, turn its lock-
ing
ring clockwise
as
far
as
it
will go to secure the plug.
Never submerge the speedlight
in
water with the
sensor socket cover removed
or
get the sensor cord
plugs wet. Always make sure either the sensor socket
cover or the sensor cord plugs are securely attached
before entering the water.
After shooting underwater, wipe off any water droplets
with a soft cloth before removing the plug to prevent
water from entering the socket. Whenever the sensor
cord
is
not being used or the speedlight
is
bei
ng washed
with the sync cord removed from the synchro socket,
attach the synchro socket cover to protect the socket.
To
attach the socket cover press
it
aga
in
st
the socket to
seat the O-ring, then turn the locking
ring
clockwise
as
far
as
it
will go.
•
To
simplify identification, both the tip
of
the sync cord's speedlight plug
and the inside
of
the synchro socket are color· coded yellow.
cord
is
not
be
i
ng
used or the speedlight
is
being washed
with the sensor cord removed from the sensor socket,
attach the sensor socket cover to protect the socket.
To
attach the socket cover, press
it
against the socket to
seat the O-ring, then turn the locking
ring
clockwise
as
far
as
it
will go.
•
To
simplifty identification, both the tip
of
the sensor
cord
's speedlight
plug and the inside
of
the sensor socket are color-coded black.
19