Filter
Top Products
Cord
Fasten
i
ng
Hanger @
This hanger secures the sync cord to the bracket to
keep it out of the way while shooting.
To
use the cord fastening hanger, attach it to the speed-
light bracket
as
shown
in
the photo, then attach the
sync cord to the hook.
Attaching the
SW-102
To
attach the adapter, align the adapter's mounting
notches with the adapter mounting catches
on
the flash
head, push the adapter onto the flash head
as
shown
in
the photo, then turn the adapter clockwise
as
far
as
it
will go.
To
remo
ve:
Turn
the adapter counterclockwise and pull
it
off.
Wide-Flash
Adapter
SW-102
®
Designed specifically for
us
e with this flash unit,
the
Wide-
Flash
Adapter
SW
-
102
increases the S8-
102
's
angle of coverage from that of a 28mm lens (on land
and
underwater) to that of a 15mm lens (underwater).
When
the adapter
is
attached, the S8-102
's
GN
is
re-
duc
ed
to
22
on
land
and
11
underwater (when using
ASA/ISO
100
film
at
" MFULL
")
.
o
When
the
SW-102
is
attached, be su
re
to use the correct shooting
situation marks
(
~
for
underwater or
~
for on-land shooting) when
setting the exposure calculation dial.
o
To
prevent overexposure during close-up shooting within approximately
O.
6m
(2ft!, attach the adapter even if using a lens other than the
UW-Nikkor 15mm fI2.
BN
.
o
To
prevent the loss
of
the
SW
-
102
and to enable it to be attached
quickly, tie one end
of
a piece
of
string to its hole and tie the other end
to the speedlight.
Target-Light
Function
The
S8-102's target-light enables the flash head to
be
accurately positioned for close-up shooting regardless
of whether or not the speedlight
is
mounted
on
the
joint/arm. When the speedlight's power switch
is
turned
on
and the
T-S
switch
®l
is
turned to "T.LlGHT" or
"T&S," the target-light will emit a beam of light to
indicate the direction of the flash head.
To
accurately
position the flash head, reset it by using the
jOint
and
arm until the beam of light falls
on
the center of the
subject.
oAlthough you can shoot while the target-light
is
on,
it
is
better to turn
the T
-S
switch to "O
FF
" or
"S
LAVE
" before shooting to conserve
battery power.
o
lf
the target-light
is
on when the flash
is
fired, the target-light will flicker
for a few moments.
This
does n
ot
indicate a malfunction.
o Recycling takes slightly longer when the target-light
is
being used.
29