Filter
Top Products
Setting Forced TTL and Forced A modes
(Applicable to all camera groups)
3
Switch the flash mode selector from OFF to AUTO while
holding down the "ZOOM" button.
TTL
A
M
M
ZOOM
ISO
mm
ft m
60
30
15
7
4
2
18
9
4
2
1
0.6
The ˙ (non-TTL Auto Flash) indictor in
the LCD panel blinks to indicate that
the SB-27 is in Forced A mode.
■Forced A mode
NOTE
• In non-TTL Auto Flash mode, choose aperture-priority auto (A) or
manual (M) exposure mode, and when the same aperture is set
on both the SB-27 and the camera, correct exposure is achieved.
• The subject will be overexposed if you set a larger (lower
f-number) aperture on the camera than on the SB-27. Conversely,
the subject will be underexposed if you set a smaller (higher
f-number) aperture on the camera than on the SB-27.
■Canceling Forced TTL and Forced A modes
4
Switch the flash mode selector from OFF to AUTO while
holding down the "ZOOM" button.
TTL
A
M
M
ZOOM
ISO
mm
ft m
60
30
15
7
4
2
18
9
4
2
1
0.6
The ˙ indicator in the LCD stops
blinking and flash operation returns
to normal TTL Auto Flash mode
(for cameras in Groups I thru VI),
and to non-TTL Auto Flash mode
(for cameras in Group VII.)