Filter
Top Products
34
EN
Viewing the image immediately after
shooting [REC VIEW]
S
SETUP X REC VIEW
Submenu 2 Application
OFF
The image being recorded is not
displayed. This allows the user
to prepare for the next shot while
following the subject in the monitor
after shooting.
ON
The image being recorded is
displayed. This allows the user to
make a brief check of the image
that was just taken.
Even when set to [ON], you can resume
shooting while the image is being displayed.
Resetting the fi le name numbers of
pictures [FILE NAME]
S
SETUP X FILE NAME
Submenu 2 Application
RESET
This resets the sequential number
for the folder name and fi le name
whenever a new card is inserted.
*1
This is useful when grouping
images on separate cards.
AUTO
Even when a new card is inserted,
this continues the numbering for
the folder name and fi le name from
the previous card. This is useful for
managing all image folder names
and fi les names with sequential
numbers.
*1
The number for the folder name is reset to 100, and
the one for the fi le name is reset to 0001.
Adjusting the CCD and adjusting
the image processing function
[PIXEL MAPPING]
S
SETUP X PIXEL MAPPING
This function has already been adjusted
at factory shipping, and no adjustment is
needed right after purchase. Approximately
once a year is recommended.
For best results, wait at least one minute
after taking or viewing pictures before
performing pixel mapping. If the camera is
turned off during pixel mapping, be sure to
perform it again.
To adjust the CCD and to adjust the
image processing function
Press the x button when [START]
(submenu 2) is displayed.
The camera checks and adjusts the CCD and the
image processing function at the same time.
●
Month: 1 to C
(A=October,
B=November,
C=December)
Day: 01 to 31
Pmdd
Folder name Folder name File name
DCIM
100OLYMP
999OLYMP
Pmdd0001.jpg
Pmdd9999.jpg
Automatic
numbering
Automatic
numbering
d4377_e_oima_000_book_cs2e.indb 34d4377_e_oima_000_book_cs2e.indb 34 7/1/2008 12:09:05 PM7/1/2008 12:09:05 PM