Filter
Top Products
75
6
Settings
Setting the date and time
This function lets you set the date and time. The date and time is saved
with each picture, and is used in the file name.
Top menu [MODE MENU] [SETUP] [X]
g“How to use the menus” (P. 16)
• In : Top menu [X]
1
Press
ac
to select one of the
following date formats: [Y-M-D]
(Year/Month/Day), [M-D-Y]
(Month/Day/Year), [D-M-Y] (Day/
Month/Year), and press
d
.
• Move to the year setting.
• The following steps show the procedure
used when the date and time settings
are set to [Y-M-D].
2 Press ac to set the year, and
press d to move to the month
setting.
• To move back to the previous setting,
press b.
• The first two digits of the year are fixed.
3 Repeat this procedure until the
date and time are completely set.
•
The time is displayed in the 24-hour format.
Consequently, 2 p.m. is displayed as 14:00.
4 Press Z.
• For a more accurate setting, press Z when the time signal hits 00 seconds.
Note
• The date and time settings return to the factory default settings if the camera is
left without batteries for approximately 3 days. The settings will be canceled
more quickly if batteries were only loaded in the camera for a short time before
being removed. Before taking important pictures, check that the date and time
settings are correct.
• If the date and time setting is canceled, a warning is displayed on the monitor
the next time the camera is turned on. g“Error codes” (P. 107)
2005
.
01 01
X
GO
OK
SET
SELECT
00 00
:
YMD
.
2005
.
01 01
00 00
:
.
X
GO
OK
SET
SELECT