Filter
Top Products
82
Camera settings
Pixel Mapping
The Pixel Mapping feature allows the camera to check a CCD and image
processing circuit automatically.
It is not necessary to operate this function frequently. Approximately once a
year is recommended. Wait a few minutes after the monitor is used or
continuous shots are taken to allow for proper performance of the Pixel
Mapping function.
1
While pressing and at the
same time, open the lens barrier.
Hold the buttons until the monitor turns on.
2
Press to select START, then
press .
When 10 seconds have passed with the PIXEL MAPPING screen
displayed, the camera automatically returns to the shooting mode.
• Do not remove the batteries or disconnect the AC adapter while Pixel
Mapping is in progress as this may cause a malfunction.
• If the power is turned off during Pixel Mapping, start again from
Step 1.
StARt
CANCEL
PIXEL MAPPING
GO
SELECt