Olympus EPL1BLK Camcorder User Manual


 
54
EN
Flash shooting
3
3
To raise the built-in ash for use, slide the ash switch. The built-in ash can be
used for ash photography in a variety of shooting conditions.
Using a ash ( ash photography)
1
Raise the ash.
2
Press the # button (I) to display the current ash mode.
3
Use HI to choose a ash mode and press i.
The options available and the order in which they are displayed vary depending on
the shooting mode. g “Flash modes that can be set by shooting mode” (P. 102)
AUTO Auto ash
The ash res automatically in low light or
backlight conditions.
#
Fill-in ash
The ash res regardless of the light
conditions.
$
Flash off
The ash does not re.
*1
!/H
Red-eye reduction
ash
This function allows you to reduce the
red-eye phenomenon. In S and M mode,
the ash always res.
#SLOW
Slow synchronization
(1st curtain)
Slow shutter speeds are used to brighten
dimly-lit backgrounds.
!SLOW
Slow synchronization
(1st curtain)/Red-eye
reduction ash
Combines slow synchronization with red-
eye reduction.
#SLOW2/
2nd CURTAIN
Slow synchronization
(2nd curtain)
The ash res just
before the shutter closes
to create trails of light
behind moving light
sources.
#FULL Manual (FULL)
*2
The ash res at full power.
#1/4 Manual (1/4)
*2
The ash res at 1/4 power.
#1/16 Manual (1/16)
*2
The ash res at 1/16 power.
#1/64 Manual (1/64)
*2
The ash res at 1/64 power.
*1 Both the built-in ash and optional external ash units turn off.
*2 Built-in ash only.
4
Press the shutter button all the way.
# Caution
In [!/H(Red-eye reduction ash)], after the pre- ashes, it takes about 1
second before the shutter is released. Hold the camera rmly to avoid camera shake.
[!/H(Red-eye reduction ash)] may not work effectively under some shooting
conditions.
When the ash res, the shutter speed is set to 1/160 sec. or slower. When shooting
a subject against a bright background with the ll-in ash, the background may be
overexposed.
Flash shooting