Filter
Top Products
Mounting the camera using the velcro strap:
1. Attach the rubberized patch to the bottom of the helmet grip.
2+3. Place the helmet grip on the helmet, and thread the velcro strap
through the helmet grip.
4. Secure the velcro strap by fastening
it through the helmet vents.
5. Slide the camera into the helmet grip,
and adjust the angle of the camera
making sure it's tight.
Mounting the camera using the handlebar grip:
1. Place the handlebar grip on the handlebar.
2. Add the screw and nut to hold the handlebar grip securely.
3. Slide the camera into the handlebar grip and make sure the handlebar grip is locked
with the camera.
4. Adjust the angle of the camera.
9
10
#1 #2
#3 #4
#5
#1 #2
#3
#4
VI) Quick Start
Battery Installation
1. Unscrew the cover at the end of the unit.
2. Place your finger on the 'lip', which is on the bottom
half of the rear of the unit, and pull in a downward
motion to open the battery slot cover.
3. Insert 2 x AA alkaline batteries into the battery slot
with the polarity in the direction as shown.
4. Replace the battery cover and screw on the end of
unit cover.
Important: When the camera is low in battery, the low
battery icon will appear on the LCD display.
Always download video footage to your PC prior to
replacing batteries to avoid memory loss.
Note:
a) Battery installation should be done under adult supervision.
b) Do not mix old and new batteries together. Replace
all the batteries at the same time.
c) Remove the batteries if the camera is not going to be
used for long periods of time. This will save battery
life.
AT18_manual_UK_31Jan2007 2/2/07 6:14 PM Page 6