Filter
Top Products
22
How to install and connect the unit
4 Mount the unit.
Align the position of the hole for checking the positioning with the status display lamp.
Align the holes on the camera main unit used to insert the bottom panel with the protrusions on the mount bracket used
for inserting the camera, push the bracket and camera firmly together, and rotate the main unit by about 15 degrees in
the direction of the arrow.
Secure the mount bracket to the unit using the main unit mounting screws (M3) as supplied.
Attach the mount bracket securely with the prescribed tool using the clamping torque below.
Be absolutely sure to verify that none of the screws are loose.
Screw diameter Clamping torque
M3 0.78 N · m (8 kgf · cm)
Main unit mounting screw (M3 screw)
(with flat washer, spring washer)
Status display lamp
Approx.
15°
On the camera
main unit: Holes
(3) used to insert
the bottom panel
On the mount
bracket: Protrusions
(3) used for
inserting the camera
Hole for checking
the positioning
Do not do this work while holding the camera head since doing so may result in malfunctioning of the unit.
Use only the screws supplied. Do not use any other screws.
Check that the unit has been mounted securely with no tilting or wobbling.
Notes
5 Check the mounting.
Check out the following points.
• The main unit mounting screws must be mounted securely.
• The unit must not tilt, and it must be mounted exactly.
• The unit must be securely installed.
• The unit pedestal part must not rotate even when an attempt is made to turn it.