Filter
Top Products
10
Preparing for shooting
1
Turn the POWER/MODE switch of the
camera <ON>. (Page 27 of Vol.1)
•
Make sure the mode lamp is lit.
2
Slide the <OPEN> lever of the memory card
slot cover down to open the cover.
3
Fully insert a memory card with the notch
up into the memory card slot.
4
Close the memory card slot cover.
•
Close until it clicks rmly into place.
Insert from the
terminal side straight
forward as shown in
the picture, until you
hear a “click”.
• Do not perform the following operations while
the memory card access lamp is ashing.
You may damage the memory card or its
contents, or cause the camera to fail to operate
correctly.
- Opening the door and removing the memory
card
- Switching off the power
- Connecting and disconnecting the USB2.0
connection cable
- Removing the battery
- Shaking or striking the camera
• Always format memory cards that have been
used on other devices when rst using them
with this camera. (Page 13)
• If [CHECK CARD.] (check the memory card.)
is displayed on the viewnder or LCD monitor,
remove the memory card and reinsert it.
• Images shot from the start of shooting until it is
stopped, are recorded as one clip.
• When recording is paused after a short
recording, time may be required after pressing
the <START/STOP> button before writing to
the memory card is completed. This means
that if the <START/STOP> button is pressed,
operations cannot be accepted immediately.
• The camera reads information from the
memory card immediately after the memory
card is inserted, therefore, after [PAUSE]
is displayed in the operation status display
(Page 72), press the <START/STOP> button to
start shooting.
• The recording formats of factory default are [PH
1080/60i] in AVCHD mode, and [DV 480/60i]
in DV mode. To check current setting status,
see “Checking and displaying shooting status”
(Page 25).
• The upper limit for the number of clips that
can be recorded in AVCHD mode on a
single memory card is 900. (However, this
number may exceed 900 clips when shooting
immediately after the POWER/MODE switch
has been turned <ON>.)
The upper limit for the number of clips that can
be recorded in DV mode is 900.
Basic shooting operations