Filter
Top Products
53
Playback
12 Indicators
•
In AVCHD mode
[
]: Shot mark
This indicates that a clip has a shot mark.
(Page 53)
[ ]: Index
This indicates that indexes have been added.
(Page 57)
[
]: Resume playback display
Displayed on clips on which resume playback
setting has been applied.
•
In DV mode
[
]: Shot mark
This indicates that a clip has a shot mark.
(Page 53)
[
W
]: Wide
Displayed on clips recorded in 16:9 angular
eld.
[
]: Resume playback display
Displayed on clips on which resume playback
setting has been applied.
[
X
] (Yellow): Defective clip (repairable
clip)
Displayed on defective clips resulted from
turning off the power during recording, etc.
These may be repaired. (Page 58)
[
X
] (Red): Defective clip (unrepairable
clip)
Displayed on defective clips resulted from
turning off the power during recording, etc.
Delete these clips because they are not
repairable. If you cannot delete these clips,
format the memory card with this camera.
(Page 13)
[
?
]: Defective clip (clip with unknown
content)
Displayed on clips with unknown content
because the content is incompatible with this
camera.
[
!
]: Incomplete clip
When the recording capacity of one
clip exceeds 4 GB (recording time is
approximately 16 minutes), the clip is
automatically split and saved as another clip.
This is displayed on clips that were not saved
successfully as associated clips due to power
being switched off during recording, etc.
•
To display CLIP PROPERTY on the
thumbnail screen, move the cursor using the
OPERATION lever to the clip you want to
display properties for, and press the <DISP/
MODE CHK> button. For details on display,
see “Clip information screen” (Page 60). Press
the <MENU> button while displaying the
properties to return to the thumbnail screen.
Adding shot marks to clips
Adding shot marks [ ] will make it easier to nd
the clips you are looking for.
1
Tilt the OPERATION lever in the < >< >
<
>< > directions to move the cursor to the
clip for which a shot mark is to be added.
2
Press the USER button to which the shot
mark function has been allocated. (Page 83)
To release a shot mark, repeat the preceding
steps.
•
It is not possible to add shot marks to clips
shot using a consumer camcorder model.
Selecting the memory card slot for
playback
You can switch the memory card slot for playback.
1
Press the <SLOT SEL> button when the
thumbnail screen is displayed in the <PB>
mode.