Filter
Top Products
- 107 -
Major confirmation/error messages to be indicated on the screen in text.
∫ It is not a malfunction in following cases
Display
Messages
CHECK CARD.
This card is not compatible or it cannot be recognized by the unit.
If this message appears even though motion pictures and still pictures are recorded on an SD
card, the card may be unstable. Reinsert the SD card, then turn the unit off and then on again.
INVALID/CANNOT SET.
Since there is a condition to use the function, it is required to cancel/change other settings.
Others
Troubleshooting
The lens or LCD monitor
fog up.
≥ This is due to condensation. It is not a breakdown. Please refer
to page 2.
A clicking sound is heard
when the unit is shaken.
≥ This is the sound of the lens moving and is not a defect.
This sound will no longer be heard when the unit is turned on
and change the mode to .
Object seems to be warped. ≥ Object seems to be warped slightly when the object moves
across the image very fast, but this is because the unit is using
MOS for the image sensor. This is not a malfunction.
Power
Problem Check points
This unit cannot be turned
on.
This unit does not stay on
long enough.
Battery runs down quickly.
≥ Charge the battery again to ensure it is sufficiently charged.
(l 12)
≥ In cold places, the battery using time becomes shorter.
≥ The battery has a limited life. If the operating time is still too
short even after the battery is fully charged, the battery has
worn out and needs to be replaced.
This unit cannot be
operated though it is
turned on.
This unit does not operate
normally.
≥ Remove the battery or AC adaptor, wait about 1 minute and
then reconnect the battery or AC adaptor. Then about
1 minute later, turn on the unit again. (Conducting the above
operation while the media is being accessed may damage the
data on the media.)
≥ If normal operation is still not restored, detach the power
connected, and consult the dealer who you purchased this
unit from.
AG-AC90-VQT4M99_mst.book 107 ページ ２０１２年９月２５日 火曜日 午後１２時６分