Filter
Top Products
- 48 -
To remove the external microphone, etc., from the audio input terminals 1, 2
(XLR 3 pin)
Remove while pushing on the PUSH section of the audio
input terminals 1, 2 (XLR 3 pin).
≥ Set the input signal to built-in microphone by switching the
CH1, CH2 switches to INT (L) or INT (R) after removing
the external microphone. Audio will not be recorded when
motion picture is recorded without switching.
≥ Set INPUT1, 2 (+48V) switches to OFF if you connect
equipment not compatible with +48 V. You can damage this unit or such equipment if you
leave the setting at ON.
≥ This unit is turned off when a problem occurs with the +48 V power supply.
≥ The battery will discharge faster if you use a phantom microphone.
≥ When inputting the external microphone signal to audio channels 1 and 2, connect the external
microphone to audio input terminal 2 (XLR 3 pin) and switch both CH1 and CH2 switches to
INPUT2.
ヱヶヴラ
A PUSH section
AG-AC90-VQT4M99_mst.book 48 ページ ２０１２年９月２５日 火曜日 午後１２時６分