Filter
Top Products
-45-
%6 Color Matrix Compensation Level Setting
[Matrix (R-G)/(R-B)/(G-R)/(G-B)/(B-R)/(B-G):
–31 - +31]
Color Matrix compensation level can be adjusted.
(R-G): To increase or decrease the intermediate
color between red and magenta
(R-B): To increase or decrease the intermediate
color between red and yellow
(G-R): To increase or decrease the intermediate
color between green and cyan
(G-B): To increase or decrease yellowish green
(B-R): To increase or decrease the intermediate
color between blue and cyan
(B-G): To increase or decrease purple
%7 Gamma Correction Level Setting
[Gamma: 0.35 - 0.55]
Gamma correction level can be set.
%8 Knee Compensation Level Setting [Knee Point:
88 % - 98 % / Dynamic]
88 % - 98 %: The level of video signals subject to
knee compensation (knee point) can be set.
Dynamic: Knee compensation level is automatically
adjusted according to the scene.
%9 White Clip Level Setting [White Clip:
95 % - 110 %]
The peak level of video signals to be white-clipped
can be set.
^0 Flare Correction Level Setting [Flare R/G/B:
0 - 100]
Flare correction level can be adjusted.
* Flare correction level has already been adjusted
prior to shipment from the factory.
^1 Black Stretch Setting [Black Stretch: ON/OFF]
Black stretch to correct the suppression of black
portions at low luminance can be set to ON or OFF.
^2 Clean DNR Setting [Clean DNR: HIGH/LOW/OFF]
Clean DNR effect can be selected.
^3 PC Control Access Speed Setting [Baud Rate:
1 200bps/2 400bps/4 800bps/9 600bps]
This setting is to select a communication speed in
controlling the camera from the computer.
^4 Negative/Positive Selection [Nega/Posi:
Posi/ Nega]
Posi: Normal image
Nega: Image is shown reversed in darkness and
color.
When an option card is added, only the composite
output and Y/C output will be reproduced in nega-
tive image.
Note