Filter
Top Products
Pan/Tilt Head Controller AW-RP400
26 (E)
ENGLISH
Menu settings
$ List of menu items and settings
PRIORITY MASTER, SLAVE MASTER
DIRECTION PAN
TILT
ZOOM
NORMAL, REVERSE NORMAL
FOCUS
IRIS
ROTATION
SPEED WITH ZOOM POS. OFF, 1, 2, 3 OFF
MEMORY LENGTH 60s, 120s, 300s, 600s 60s
PRESET SPEED 1 to 25 25
IRIS CONTROL BOTH, RP400, CB400 BOTH
ROTATION SWITCH ROTATION, FOCUS, ZOOM, IRIS ROTATION
OPTION SWITCH A
B
C
NOT USE, LAMP, EFROSTER, WIPER,
D
HEATER/FAN, AF, ND, OPTION, NOT USE
E
EXTENDER
F
G
H
CONTROL SELECT MODE INTERLOCK, UN-INTERLOCK INTERLOCK
MONITOR2 SELECT (When the controller CB400, SLAVE CB400
is the master)
(When the controller RP400, CB400 RP400
is the slave)
BUZZER OFF, ON ON
AUTO RUN START No. 1 to 50 1
END No. 1 to 50 50
INTERVAL 1s to 30s 1s
OPERATE STOP, RUN STOP
SD CARD STORE, LOAD – – –
Menu item Setting Description Initial value
PRIORITY (MASTER/SLAVE)
When two AW-RP400 pan/tilt head controllers have been connected, the priority of the CONTROL SELECT buttons is to be
set.
When MASTER is selected as the setting, the master AW-RP400 has priority; when SLAVE is selected, the slave AW-RP400
has priority.
If the AW-RP400 controller with a high priority has selected the pan/tilt heads, which were selected by the AW-RP400
controller with a low priority, the CONTROL SELECT button lamps on the AW-RP400 controller with the low priority start
flashing to indicate that the control rights have been ceded to the other controller. This setting is performed using the master
AW-RP400 controller.