Filter
Top Products
Operating Instructions
[For assistance, please call: 1-800-272-7033] 105
6.1.9 Resetting the Camera to Factory Default
All camera settings are reset to factory default when the Execute button is clicked.
To restore the wireless connection, access the camera by using a wired connection
and set up the wireless configuration. (For BL-C20A, see Getting Started.)
1. Click [Reset to Factory Default] on the Maintenance page.
2. Click [Execute].
• The indicator blinks orange, and then turns off for 5 seconds.
• All camera settings (user name, password, IP address, subnet mask etc.)
are reset to factory default.
• If the camera is reset to factory default, the network connection mode
changes to [Automatic Setup]. Reconfigure the camera referring to
Getting Started.
Note
• The internal clock will not be reset, but the time format will return to AM/
PM mode (see page
48).
• See page 109—page 117 for the default settings.
• Pressing the FACTORY DEFAULT RESET button resets the camera to
factory default (see page
108).
• All buffered images on the internal memory are deleted when resetting the
camera to factory default.
• The reset operation takes about 1 minute.
• Do not turn off the camera during the reset operation.
• If the camera is restarted, all sensor logs are deleted.