Panasonic BL-VP100 Security Camera User Manual


 
Note
The screen is refreshed in 10 seconds intervals periodically to monitor the radio wave status. This may
cause the screen to flicker.
[Wireless module status]
Displays the current status of the wireless module.
[Firmware version (Wireless)]
Displays the wireless firmware version of the camera.
[Operation mode]
Displays the camera's operation mode (Wired or Wireless).
[Auto setup (WPS)]
When the camera has successfully completed Wi-fi Protected Setup (WPS) settings with the wireless router,
“Already been set” is displayed.
If the wireless settings are manually changed after “Already been set” is displayed, “Not set” will be displayed.
The “Already been set” display is linked to the camera's WIRELESS indicator (green light).
[Mac address of the wireless module]
Displays the camera's wireless module's MAC address. When the wireless router limits access with MAC
address filtering, register the wireless module's MAC address displayed here (the camera's MAC address) to
the wireless router. (®page 156)
[Communication mode]
Displays the currently used communications mode (802.11b/g, 802.11n/b/g [ShortGI disabled], or 802.11n/b/
g [ShortGI enabled]).
[SSID]
Displays the connected wireless router's SSID (network identification name).
[Channel]
Displays the connected wireless router's wireless channel.
Operating Instructions 149
16 Use the camera on a wireless LAN [Wireless] (BL-VT164W/BL-VP104W)