Filter
Top Products
Others
106
VQT1J82
Troubleshooting
If you return the menu settings to the initial
settings at the time of purchase, the
condition may improve.
Select [RESET] in the [SETUP] menu.
(P19)
∫ Battery and power source
1: The camera cannot be operated even
when it is turned on.
•Is the battery inserted correctly?
–Check the direction of the battery.
(P12)
•Is the battery sufficiently charged?
–Use a battery that has been
sufficiently charged.
2: The LCD monitor turns off while the
camera is turned on.
•Is power save mode (P18) or economy
mode (P18) activated?
–Press the shutter button halfway to
cancel these modes.
•Is the battery exhausted?
–Use a battery that has been
sufficiently charged.
3: The camera turns off immediately
after it is turned on.
•Is the battery charge insufficient to
operate the camera?
–Use a battery that has been
sufficiently charged.
–If you leave the camera on, the
battery will be exhausted. Turn the
camera off frequently by using power
save mode (P18) etc.
∫ Recording
1: The picture cannot be recorded.
•Is the mode dial correctly set?
•Is there any memory remaining on the
built-in memory or the card?
–Before recording, delete some
pictures. (P28)
2: The recorded picture is whitish.
The lens is dirty
•The picture can become whitish if there
is dirt e.g. fingerprints on the lens. If the
lens is dirty, turn on the camera, eject
the lens barrel (P9) and gently wipe the
lens surface with a soft dry cloth.
3: The recorded picture is too bright or
dark.
•Check that the exposure is correctly
compensated. (P39)
4: 2 or 3 pictures are taken at one time.
•Is auto bracket (P40),
[HI-SPEED BURST] in scene mode
(P47) or burst mode set? (P63)
5: The subject is not focused properly.
•The focus range varies depending on
the recording mode.
Rotate the mode dial to set the proper
mode for the distance to the subject.
•Is the subject beyond the focus range of
the camera? (P22, 40)
•Have you taken a picture with jitter?
•Did you take the picture after pressing
the shutter button halfway? The subject
is not focused until the shutter button is
pressed halfway. (However, this
excludes intelligent auto mode [ ].)
6: The recorded picture is blurred. The
optical image stabilizer is not
effective.
•The shutter speed will become slower
and the optical image stabilizer function
may not work properly when taking
pictures especially in dark places. In
this case, we recommend holding the
camera firmly with both hands when
taking pictures. (P22) We recommend
using the self-timer (P38) when taking
pictures with a slow shutter speed.
7: The recorded picture looks rough.
Noise appears on the picture.
•Is the ISO sensitivity high or the shutter
speed slow?
(ISO sensitivity is set to [AUTO] when
the camera is shipped. Therefore, when
taking pictures indoors etc. the ISO
sensitivity increases.)
–Decrease the ISO sensitivity. (P59)
–Set [COL.MODE] to [NATURAL].
(P65)
–Take pictures in bright places.
•In [HIGH SENS.] (P46) and
[HI-SPEED BURST] (P47) in scene
DMC-FX33_ENG.book 106 ページ ２００７年７月９日 月曜日 午後１２時５８分