Filter
Top Products
VQT1R87
86
Advanced (Playback)
Press [‚] to return to the menu screen.
• Press [MENU/SET] to close the menu.
∫ Canceling all the [PROTECT] settings
1 Select [CANCEL] on the screen shown in step 2 and then press [MENU/SET].
2 Press 3 to select [YES] and then press [MENU/SET].
3 Press [MENU/SET] to close the menu.
•
If you press [MENU/SET] while canceling protection, the canceling will stop halfway.
Note
•
The protect setting may not be effective on other equipment.
• Even if you protect pictures in the built-in memory or a card, they will be deleted if the built-in
memory or the card is formatted.
• Even if you do not protect pictures on an SD Memory Card or an SDHC Memory Card, they
cannot be deleted when the card’s Write-Protect switch is set to [LOCK].
You can add the audio after taking a picture.
Select [AUDIO DUB.] on the [PLAYBACK] mode menu. (P18)
Note
•
Audio dubbing may not work properly on pictures recorded by other equipment.
Select the picture, and then press
[MENU/SET].
When [MULTI] has been selected
•
Repeat these steps for each picture.
• The settings are canceled when [MENU/
SET] is pressed again.
[SINGLE] [MULTI]
Press 2/1 to
select the picture.
Press 3/4/2/1
to select the
pictures.
B [AUDIO DUB.]
Press 2/1 to select the picture and then press
[MENU/SET] to start audio recording.
• The message [OVERWRITE AUDIO DATA?] screen appears
when audio has already been recorded. Press 3 to select [YES]
and then press [MENU/SET] to start audio recording. (The
original audio is overwritten.)
• Audio is recorded from the built-in microphone on the camera.
• If you press [‚], the audio dubbing is canceled.
Press [MENU/SET] to stop recording.
• It will automatically stop after recording about 10 seconds without
pressing [MENU/SET].
Press [‚] to return to the menu screen.
• Press [MENU/SET] to close the menu.
3
4
1
2
3
4
VQT1R87.book 86 ページ ２００８年６月２８日 土曜日 午後４時８分