Filter
Top Products
Others
94
∫ Battery
The battery is a rechargeable lithium ion
battery. Its ability to generate power is
based upon the chemical reaction that
takes place inside it. This reaction is
susceptible to the surrounding temperature
and humidity, and, if the temperature is too
high or too low, the operating time of the
battery will be shorter.
Be sure to remove the battery after use.
Store the removed battery in the battery
carrying case.
When you go out, bring charged spare
batteries.
•Be aware that the operating time of the
battery becomes shorter under low
temperature such as skiing grounds.
•When you travel, be sure to prepare the
supplied charger to charge the battery on
the spot.
If you drop the battery accidentally,
check to see if the battery body and
terminals are damaged.
•Inserting damaged battery in the camera
may damage the camera.
After use, be sure to remove the card
and the battery or disconnect the plug
from the electrical outlet.
•Extremely high or low temperatures will
shorten the life of the battery.
•If the battery is kept in smoky or dusty
places, the terminals may rust and cause
malfunctions.
Dispose of an unusable battery.
•The battery has a limited life.
•Do not throw the battery into fire because
it may cause an explosion.
Do not allow the battery terminals to
come in contact with metal objects
(such as necklaces, hairpins, etc.).
•This can result in a short circuit or heat
generation and, if you touch the battery in
this condition, you may be badly burned.
∫ Charger
•If you use the charger near a radio, radio
reception may be disturbed. Keep the
charger 1 m or more away from radio.
•When the charger is in use, it may
generate whirring sounds. However, this is
not a malfunction.
•After use, be sure to disconnect the AC
cable from the electrical outlet. (If it is left
connected, a minute amount of current is
consumed.)
•Keep the terminal of the charger and
battery clean.
∫ Condensation (When the lens is
fogged up)
When condensation has taken place:
•Turn the camera off and leave the camera
in this condition for about 2 hours. When
the camera becomes close to the ambient
temperature, the condensation
disappears naturally.
•When you move the camera from a cold
place to a hot place, put the camera into
plastic bag and then take it out after the
temperature of the camera becomes close
to the ambient temperature to avoid
condensation.
Condensation may cause a malfunction in
the camera.
Be careful to avoid condensation and take
proper measures when condensation
occurs.
FX2_7-GN.book 94 ページ ２００４年８月２日 月曜日 午後３時４０分