Filter
Top Products
Others
135
VQT0S00
3: The picture played back looks rough.
Noise appears on the picture.
• Is the ISO sensitivity is high or is the
shutter speed slow?
– Decrease the ISO sensitivity. (P84)
– Have you set [NOISE REDUCTION]
in [PICT.ADJ.] to [HIGH] or items
other than [NOISE REDUCTION] to
[LOW]? (P92)
– Take pictures in bright places.
4: The folder number and the file number
are displayed as [—] and the screen
may turn black.
• Is the picture edited with a PC or
recorded with the digital camera other
than Panasonic?
This may also result if the battery is
removed immediately after recording or
by recording with the exhausted battery.
– In order to delete the pictures
mentioned above, format the data.
(P115) (Once formatted, all the data
including the other pictures cannot be
restored. Confirm carefully to format.)
∫ TV, PC and printer
1: The picture does not appear on the
television.
• Is the camera connected to the TV
correctly?
• Set the TV input to external input mode.
2: When connecting to a PC, pictures
cannot be transferred.
• Is the camera connected to the PC
correctly?
• Is the camera recognised by the PC
correctly?
• Set [USB MODE] to [PC]. (P117)
3: The card is not recognised by the PC.
• Disconnect the USB connection cable
and then connect it again with the card
inserted into the camera.
4: The pictures cannot be printed with
the camera connected to printers.
• Is the printer supporting PictBridge?
– You cannot print pictures with printers
which do not support PictBridge
(P121).
• Set [USB MODE] to [PictBridge (PTP)].
(P117)
5: The ends of the pictures are cut at
printing.
• When using the printer with a trimming
feature or other feature which cuts out
both edges of the pictures, cancel the
feature for printing. The feature
depends on the printer used. (Refer to
the operating instructions of the printer
for details.)
• When you order photo studios to print
pictures, ask the photo studio if the
pictures can be printed with both ends.
6: The display areas on the TV screen and
the camera’s LCD monitor are different.
With some TV models, the area display
is smaller so the top and bottom or left
and right of the picture may appear cut
off when the picture is displayed. This is
not a malfunction. In this case, check the
picture on the camera’s LCD monitor.
∫ Others
1: Unreadable language was selected by
mistake.
• Press the [MENU] button and select
[ ] icon on the [ SETUP] menu to
set the desired language.
2: The setting for the auto review
function is disabled.
• Is the camera in burst mode (P57), auto
bracket (P55) or motion picture mode
[ ] (P69), or is [AUDIO REC.] set to
[ON] (P87)?
– In these cases, you cannot set the
auto review function in the [SETUP]
menu.