Filter
Top Products
Preparation
18
VQT0P65
Inserting/Removing the Batteries
• Check that the camera is turned off and
that the lens is retracted.
• Use oxyride batteries (supplied), alkaline
batteries (optional) or Ni-MH batteries
(optional).
1 Slide the battery door to open it.
2 Insert the batteries observing the
direction of the + and -
polarities.
3 1 Close the battery door.
2 Slide the battery door to the
end and then close it firmly.
• Select the type of battery in use on
[BATTERY TYPE] in the [SETUP] menu.
(P24)
• If you will not be using the camera for a
long time, remove the batteries.
• When new batteries or fully charged
Ni-MH batteries have been inserted for
more than 3 hours, the clock setting is
stored (in the camera) for at least
3 months even if the batteries are
removed. (The storing time may be
shorter if the batteries are not charged
sufficiently.)
If more than 3 months has passed, the
clock setting will be lost. In this case, set
the clock again. (P23)
• Do not remove the card and the
batteries during an access. The data
on the built-in memory or the card may
be damaged. (P21)
• Remove the batteries after the LCD
monitor and the status indicator
(green) are turned off. Otherwise, the
settings on the camera may not be
stored properly.
LZ2_1PP.book 18 ページ ２００５年１月１４日 金曜日 午前７時５６分