Panasonic DMC-TZ25 Camera Flash User Manual


 
- 13 -
Charging battery
Charging lamp indications
On: Charging in progress
Off: Charging stops (After charging is stops, disconnect the camera from the electrical
outlet or your computer.)
Notes on charging time
When using the AC adaptor (supplied)
Charging time Approx. 260 min
• The charging time indicated above is the time required for charging in the case when
the battery is completely used up. The time required for charging differs depending on
conditions of battery usage. Charging takes longer in cases when temperatures are
either high or low and when the battery has not been used for a long period of time.
• The time required for charging through the computer varies depending on the
specifications of the computer.
Do not use any other USB connection cables except the supplied one. Doing so may
cause malfunction of the camera.
Do not use a USB extension cable.
The AC adaptor (supplied) and the USB connection cable (supplied) are dedicated
accessories of this camera. Do not use it for other devices.
If there is any trouble related to the electrical outlet (i.e. power failure), charging may
not complete properly. Disconnect the USB connection cable (supplied) and reconnect
it to the camera.
If the charging lamp does not light or flashes even when the camera is properly
connected to the AC adaptor (supplied) or your computer, charging has been put in
pause status because the temperature is not in the appropriate range for charging
and it is not a malfunction. Reconnect the USB connection cable (supplied) and retry
charging in a place where ambient temperature is 10 °C to 30 °C (50 °F to 86 °F)
(temperature conditions also apply to the battery itself).
Remaining battery
Remaining battery (only when using battery)
(flashes red)
If the battery mark flashes red, recharge or replace battery.