Filter
Top Products
9
(ENG) VQT4Q07
Press the [ON/OFF] button.
≥The control panel display will turn on.
≥
To turn the flash off, press the [ON/OFF] button again.
≥Replace the batteries if the [TEST/CHARGE] lamp does not light after:
≥If the [TEST/CHARGE] lamp and [AUTO CHECK] lamp blink simultaneously,
batteries are running low. Replace the batteries. Using a considerably
exhausted battery may result in malfunction.
≥The flash will enter sleep mode whenever the camera enters sleep mode.
≥If no operations are performed for approximately 60 minutes, the flash will turn off
automatically. Press the [ON/OFF] button to turn it on.
≥Oscillating sound may be output while charging the flash, but this is not
malfunction.
Shooting
1 Use camera controls to choose the flash mode.
See the camera operating instructions for details.
2 Choose a flash mode.
“Flash Mode” (P10)
• The camera and flash will exchange shooting information and the flash working
range will be displayed in the control panel.
3 Press the shutter button halfway.
• Flash range varies with camera settings (ISO sensitivity, aperture, and lens
focal length).
4 Press the shutter button the rest of the way down to take the
picture.
The unit emits light in proper exposure if [AUTO CHECK] lamp flashes for
approximately 5 seconds.
≥When using a flash, flash light may be blocked by the lens body, lens hood, etc.
≥Use the wide panel to prevent overexposure at ranges of less than 1 m (3.3 feet)
(P13).
30 seconds (Alkaline dry batteries)
10 seconds (Rechargeable nickel metal hydride batteries)
1Flash mode
2Lighting angle
Displayed according to the focal length of the
lens.
3[AUTO CHECK] lamp
4Light working range
VQT4Q07_PP_E_GK.book 9 ページ ２０１２年１０月２３日 火曜日 午前９時３９分