Filter
Top Products
FRONT SW
(Button operation
via front face)
11
ON
HD
PROGRE.
NOT USE
FRONT SW
OFF
SD
INTER.
NOT USE
RS–232C
DC 12V INRS– 232CS –VIDEORGB/YPbPr
1
2
3
4
OUT
VIDEO SYNC
IN
ON
1234
!4
!5
!7
@0
@1
!3
!6
!9
!8
ON
HD
PROGRE.
NOT USE
FRONT SW
ON
1234
OFF
SD
INTER.
NOT USE
RS–232C
OUT
VIDEO SYNCSDI
IN
DC 12V INRS– 232CS – VIDEORGB/YPbPr
1
2
3
4
12
!5!4
@2
!7
!8!9
@0
@1
!6
● GP-US932CUS, GP-US932CUSE
● GP-US932CU, GP-US932CUE
<Rear>
!3 HDMI output connector [HDMI] (* only for GP-
US932CU, GP-US932CUE)
This connector is used when an HDMI-ready monitor is
connected.
!4 Video output connector [VIDEO]
This connector provides composite video signals (1.0
V[P-P], 75 ohms).
!5 Synchronizing signal output/input connector [SYNC]
When an external device is synchronized, set the syn-
chronizing signal output/input selection switch !6 to "IN"
to provide the synchronizing signal input.
When the synchronizing signal output/input selection
switch !6 is set to "OUT", the connector provides the
synchronizing signal output conformable to the video
format of this system.
Important:
• The video format shall be the same among the syn-
chronized devices.
!6 Synchronizing signal output/input selection switch
[OUT/IN]
This switch toggles synchronizing signals between out-
put and input.
When the synchronizing signal output is selected, set
this switch to "OUT". When the synchronizing signal
input is selected, set this switch to "IN".
!7 Function setup switches
These switches select a video format for RGB/YPbPr
output connector, SDI output connector, and HDMI out-
put connector.
Switch OFF ON
1
2
SD (SD signal output)
INTER.
(Interlace output)
HD (HD signal output)
PROGRE.
(Progressive output)
3
4
Video
format
Switch
21
RGB/YPb
Pr output
SDI
output
HDMI
output
OFFON1 080i
bbb
ONON720p
bbb
ONOFF480p (576p*)
b
X
b
OFFOFF480i (576i*)
bb
X
NOT USE (Not used)
RS-232C
(RS-232C control)
NOT USE (Not used)
X: No output is provided.
* The value is for GP-US932CUE/GP-US932CUSE.
Note:
• When the RS-232C port is used, set Switch 4 to
"OFF" after turning off the power.
When Switch 4 is set to "OFF", button operations on
the front face are disabled.