Filter
Top Products
136
VQT2M51
≥ If the temperature of the battery is
extremely high or extremely low, charging
may take time or the battery may not be
charged.
≥ If the charging lamp keeps flashing, make
sure that the terminals of the battery or the
AC adaptor are not exposed to dirt, foreign
objects or dust, then reconnect them
properly.
Disconnect the AC cable from the AC
outlet when you remove dirt, foreign
objects or dust on the terminals of the
battery or the AC adaptor.
If the charging lamp is still flashing, the
temperature of the battery may be
extremely high or extremely low or
something may be wrong with the battery
or AC adaptor. Contact consumer support.
(l 152, 153)
≥ If you use the AC adaptor near a radio,
radio reception may be disturbed. Keep
the AC adaptor 1 m (3.3 feet) or more
away from the radio.
≥ When using the AC adaptor, it may
generate whirring sounds. However, this is
normal.
≥ After use, be sure to disconnect the AC
adaptor. (If it is left connected, a minute
amount of current is consumed.)
≥ Always keep the electrodes of the AC
adaptor and battery clean.
About charging errors
When the status indicator is flashing at a
particularly fast or slow rate, the
following should be considered.
Flashing with approx. 4 second period
(off for approx. 2 seconds, on for approx.
2 seconds):
≥ The battery may be over-discharged, or
the battery temperature may be high or
low. The battery will charge, but it may
take several hours for normal charging to
begin.
Flashing with approx. 0.5 second period
(off for approx. 0.25 second, on for
approx. 0.25 second):
≥ The battery is not charged. Remove the
battery from the unit, and try charging
again.
≥ Check that the terminals of the unit or
battery are not dirty or covered with a
foreign object, and connect the battery
correctly once again. If a foreign object or
dirt is present, turn off the unit before
removing.
≥ The battery or environment is at an
extremely high or low temperature. Wait
until the temperature has returned to an
appropriate level and try charging again. If
you are still unable to charge, there may
be a fault in the unit, battery or AC
adaptor.
Off:
≥ Charging has finished.
≥ If the status indicator stays off despite the
charging being unfinished, there may be a
fault in the unit, battery or AC adaptor.
≥ Refer to page 135 for details on the
battery.
About the AC adaptor
HDCSD60_TM60_HS60-P_PC-VQT2M51_eng.book 136 ページ ２０１０年１月１８日 月曜日 午前１１時３３分