Filter
Top Products
12
VQT3B18
Quick Guide
∫ Charging the battery
1 Connect the AC cable to the AC adaptor
and the AC outlet.
2 Insert the battery into the AC adaptor by
aligning the arrows.
∫ Inserting the battery
Install the battery by inserting it in the
direction shown in the figure.
A Insert the battery until it clicks and locks.
∫ Inserting/removing an SD card
1) Open the LCD monitor.
≥ Check that the access lamp has gone off.
2) Open the SD card/terminal cover and
insert (remove) the SD card into (from)
the card slot.
≥ Face the label side B in the direction
shown in the illustration and press it
straight in as far as it will go.
≥ Press the center of the SD card and then
pull it straight out.
3) Securely close the SD card/terminal
cover.
≥ Securely close it until it clicks.
∫ Turning the unit on/off
Turning the unit on and off with the
power button
Press the power button to turn on the unit.
A The status indicator lights on.
≥ To turn off the unit, hold down the power
button until the status indicator goes off.
Turning the unit on and off with the LCD
monitor/viewfinder
Opening the LCD monitor or extending the
viewfinder turns on the unit. Closing the LCD
monitor/viewfinder turns off the unit.
To turn on the unit
A The status indicator lights on.
Access lamp [ACCESS] A
≥ When this unit is accessing the SD
card, the access lamp lights up.
Charging lamp
[CHARGE] A
Lights up:
Charging
Goes off:
Charging completed
HDC-SDT750&TMT750-P-VQT3B18_mst.book 12 ページ ２０１０年８月２０日 金曜日 午後３時５３分