Filter
Top Products
-10-
User preference stored can be accessed by selecting
user switch.
1. Remove the switch cover on the rear of the camera
control unit by removing the screw.
8 (NC)
9
Reset All
Settings
Invalid Invalid
7
AGC/ELC
Sensing Zone
Invalid
0: ALL
1: CENTRE
2: S CIRCLE
3: M CIRCLE
4: L CIRCLE
Item No.
Item Adjust control
@3
Select switch
@4
0
G/L H Phase Valid Invalid
1
G/L SC
Coarse/Phase
Valid
Valid 0:0°
1:90°
2:180°
3:270°
2 DTL Level Valid Invalid
3 Chroma Gain Valid Invalid
4
Colour Matrix
(R-G)
Valid Invalid
5
Colour Matrix
(B-G)
Valid Invalid
6 Pedestal Level Valid Invalid
AGC/ELC Sensing Zone (Item No. 7)
0:ALL 1:CENTRE 2:S CIRCLE
3:M CIRCLE 4:L CIRCLE
Note: Item 1 and 2 settings are not stored at each user
file distinctively.
5. Select or adjust the level of each item by the User
File Select switch @4 or User File Adjust control @3.
6. Press User File Set switch @1 to store the adjusted
value in the memory.
7. Repeat the above steps 4 to 6 set the other items.
8. After all the necessary items have been set, set Use
File Set ON/OFF Switch @5 to OFF.
9. Place the switch cover back on the switch panel on
the rear of the camera control unit and fasten it with
the screws.
2. Select a desired user file (1 - 4) by turning User
Switch !0 on the front panel.
3. Set User File Set On/Off Switch @5 on the rear panel
to ON.
4. Select an item for adjustment by turning User File
Item Switch @2 on the rear panel.
The item numbers and the corresponding items are
shown below.
Do not set User File Item switch @2 to A through F
positions.
If A to F is selected, use both User File Item switch @2
and User File Select switch @4 to the position F, then
press User File Set switch @1.
Caution
0
1
ON
2 3 4 5 6 7 8
@2 @3 @4@1
@5
@7 @9 #1
#2#0@8@6
@0
F
E
D
C
B
A
9
8
7
6
5
4
3
2
1
0
F
E
D
C
B
A
9
8
7
6
5
4
3
2
1
Screw
USER FILE SETTING