Operating Instructions
106
6.1.8 Resetting the Camera to Factory Default
All camera settings are reset to factory default when the Execute button is clicked.
1. Click [Reset to Factory Default] on the Maintenance page.
2. Click [Execute].
• The indicator blinks orange, and then turns off for 5 seconds.
• All camera settings (user name, password, IP address, subnet mask, etc.)
are reset to factory default.
• If the camera is reset to factory default, the network connection mode
changes to [Automatic Setup]. Reconfigure the camera referring to
Getting Started.
Note
• Do not turn off the camera during the reset operation.
• The internal clock will not be reset, but the time format will return to AM/
PM mode (see page
49).
• See page 110—page 117 for the default settings.
• Pressing the FACTORY DEFAULT RESET button resets the camera to
factory default (see page
109).
• All buffered images on the internal memory are deleted when resetting the
camera to factory default.
• The reset operation takes about 1 minute.
• If the camera is restarted, all sensor logs are deleted.
