Filter
Top Products
96 LSQT1426 97LSQT1426
Others
3
Messages
This section explains the main messages appearing on the LCD monitor and
how to deal with them.
Message What to check
CANNOT RECORD.
Writing on the SD card failed.
NO DATA.
Neither motion pictures nor still pictures are recorded
on the SD card.
Data is recorded on the SD card, but if this message
appears, the card may be unstable.
Shut power off and turn back on.
THIS CARD CANNOT
RECORD IN VIDEO
MODE.
An 8 MB or 16 MB SD card cannot be used in Video
Recording Mode.
CHECK CARD.
The SD card is not supported or cannot be recognized
by the unit.
CARD LOCKED.
The SD card is write-protected. (P.19)
CARD FULL.
The SD card cannot be recorded on because it is full
or the numbers of scenes or numbers of scenes for
the date has reached the maximum. Either delete
unnecessary scenes or insert a new card. (P.62)
SCENE NUMBER IS
FULL
CANNOT RECORD.
THE NUMBER OF
PROGRAM IS FULL.
CARD DOOR OPENED.
Close the card/battery door.
ERROR OCCURRED.
RECORDING IS
STOPPED.
Use a Panasonic SD card or other SD card
applicable for motion picture recording. (P.18)
If this message appears when an applicable
card is used, it is recommended to format the
card. Formatting deletes all data on the SD card.
Therefore, save data on a computer or other device
before formatting the card.
●
●
EXIT THE MENU THEN
CHANGE TO MANUAL
MODE.
Functions that cannot be used simultaneously were
selected. (P.103)
CANCEL MAGICPIX
MODE.
Message What to check
PLEASE CONNECT AC
ADAPTOR
You tried connecting the unit to a computer without
connecting the AC adaptor.
ERROR OCCURRED.
PLEASE TURN UNIT
OFF, THEN TURN ON
AGAIN.
The unit detected an error. Eject the SD card and shut
power off and turn back on.
DISCONNECT USB
CABLE.
The unit is not properly connected to a computer or
printer.
Disconnect and reconnect the USB cable.
CANNOT OPERATE
WHILE CONNECTED
TO COMPUTER.
Power to the unit cannot be shut off while it is
connected to a computer.
Disconnect USB cable.
CARD ERROR HAS
OCCURRED.
TO REPAIR THE CARD, PLEASE
CONNECT AC ADAPTOR OR
CHANGE BATTERY.
The data on the SD card contains errors.
To repair the data, either use a battery of sufficient life
or connect the AC adaptor. Depending on the error, it
may take time to repair the data.
NOW REPAIRING
DATA.
DO NOT REMOVE
CARD.
The data has been repaired.
Depending on the situation, the data may not be
completely repaired.
If power is shut off without repairing data, data can
be repaired the next time that power is turned on.
If repairing fails, the data cannot be played back.
Format the SD card with this unit.
Do not repair SD cards recorded on other devices
on this unit.
●
●
●
●
CANNOT CHECK
CONNECTED DEVICE.
DISCONNECT THE
USB CABLE FROM
THIS UNIT.
A device that cannot be used with this unit is
connected to the unit.
ENVIRONMENT TOO
DARK, OR LENS
COVER CLOSED.
Before recording, open the lens cover.
This message may appear if you try to record in an
extremely dark place
After the power is turned on, the message is
displayed when the initial recording mode is
established, but it is not displayed when manual
recording is performed.
●
●
●