Filter
Top Products
23VQT1R00
Setup
3
Inserting/Removing SD
cards (sold separately)
SD cards are sold separately.
Preparations: Set the mode dial to [OFF].
(Check that the status indicator is out.)
Inserting or removing an SD card with the power ON may
damage the unit and destroy data on the card.
Place label upwards.
● While the card access lamp is lit, reading, recording, playback, deletion
or other processing is being executed. Performing the following
operations while the lamp is lit may damage the SD card and its content
and the unit may not function properly.
• Switching off power
• Removing battery or AC adaptor
• Opening card/battery door and removing SD card
• Rotating the mode dial
• Shaking or impacting the unit
Card access lamp
2
Insert/Remove the SD
card.
• To insert:
Face the label upwards and slide
the card in straight until hearing it
catch.
• To remove:
Press the center of the SD card and
pull the card out straight.
1
Open the card/battery
door.
Open the door by sliding the card/
battery door lever to the “OPEN”
position.
3
Close the card/battery
door.
• Close the card/battery door and
slide the card/battery door lever to
the “LOCK” position.
• If the door does not close
completely, remove the SD card,
check its orientation and reinsert it
into the slot.