Filter
Top Products
89VQT1R00
This section explains the main messages appearing on the LCD monitor and
how to deal with them.
Message What to check
PLEASE CONNECT AC
ADAPTOR
You tried connecting the unit to a computer without
connecting the AC adaptor.
ERROR OCCURRED.
PLEASE TURN UNIT
OFF, THEN TURN ON
AGAIN.
The unit detected an error. Eject the SD card and shut
power off and turn back on.
DISCONNECT USB
CABLE.
The unit is not properly connected to a computer or
printer.
Disconnect and reconnect the USB cable.
CANNOT OPERATE
WHILE CONNECTED
TO COMPUTER.
Power to the unit cannot be shut off while it is
connected to a computer.
Disconnect USB cable.
CARD ERROR
DETECTED.
The data on the SD card contains errors.
To repair the data, either use a battery of sufficient life
or connect the AC adaptor. Depending on the error, it
may take time to repair the data.
NOW REPAIRING
DATA.
The data has been repaired.
● Depending on the situation, the data may not be
completely repaired.
● If power is shut off without repairing data, data can
be repaired the next time that power is turned on.
● If repairing fails, the data cannot be played back.
Format the SD card with this unit.
● Do not repair SD cards recorded on other devices
on this unit.
CANNOT CHECK
CONNECTED DEVICE.
DISCONNECT THE
USB CABLE FROM
THIS UNIT.
A device that cannot be used with this unit is
connected to the unit.
ENVIRONMENT TOO
DARK, OR LENS
COVER CLOSED.
● Before recording, open the lens cover.
● This message may appear if you try to record in
extremely dark place
● After the power was turned on, the message
is displayed when the initial recording mode is
established, but it is not displayed when manual
recording is performed.