Filter
Top Products
The preset values for SHUTTER (electronic shutter
speed) change by pressing L or M as follows:
4. Gain Control Setting (AGC ON/OFF)
You can select an automatic gain control (AGC) mode
with dynamic noise reduction (DNR) options.
1. Move the cursor to AGC and select a mode.
OFF: Applies neither AGC nor DNR.
ON (DNR-H): Applies AGC with high-level DNR.
ON (DNR-M): Applies AGC with middle-level DNR.
ON (DNR-L): Applies AGC with low-level DNR.
-28-
2-3.
Compensating Flare Phenomenon (PEAK MODE)
There may be cases where the lens causes the dis-
played picture to sway like a flare especially when a
strong light is input. You can compensate for this unde-
sired effect.
Move the cursor to PEAK MODE, and select ON or OFF.
ON: Compensates flaring of the picture.
OFF: Does not compensate.
3. Shutter Speed Setting (SHUTTER)
Note: When ELC is selected for ALC/ELC on the CAM
SET UP menu, this item is not available.
You can select an electronic shutter speed of 1/60
(OFF), 1/100, 1/250, 1/500, 1/1 000, 1/2 000, 1/4 000, or
1/10 000 seconds.
Move the cursor to the SHUTTER parameter and select
the electronic shutter speed.
** CAM SET UP **
CAMERA ID OFF
ALC/ELC ALC
SHUTTER OFF
AGC ON(DNR-H)
SENS UP OFF
SYNC INT
WHITE BAL ATW1
MOTION DET OFF
LENS DRIVE DC
END SET UP ENABLE
↵
↵
↵
↵
OFF (1/60) 1/100
1/10 000 1/4 000 1/2 000 1/1 000
1/250 1/500
** CAM SET UP **
CAMERA ID OFF
ALC/ELC ALC
SHUTTER OFF
AGC ON(DNR-H)
SENS UP OFF
SYNC INT
WHITE BAL ATW1
MOTION DET OFF
LENS DRIVE DC
END SET UP ENABLE
↵↵
↵
↵