Filter
Top Products
-12-
● Video Output Connection
Connect the video output cable to the monitor or other
system device with the procured coaxial cable. The
maximum extensible length is shown in the table.
● Control Connector
Connect the respective peripherals to supply and
receive control signals. Use the supplied 5-pin cable
adapter. For electrical ratings, refer to SPECIFICA-
TIONS.
● Network Port Connection
Connect the network port to a PC or a network via a
hub with a 10BASE-T/100BASETX cable. Use the sup-
plied adapter (RJ-45, female-female) if necessary.
Note: For network system connections, refer to ■
Network Connection Types.
Alarm out
Wire colour Function
Example of
peripherals
Black1 Alarm in Door switch
Grey2 Buzzer
Pink3 AUX out Lighting lamp
Red4 Day/night in Optical sensor
Green5 GND Signal ground
Pin#
■ Image Adjustment
You can manually adjust the pan/tilt/azimuth angles,
focus, and zoom while observing the connected moni-
tor.
Notes:
• Do not hold the camera by the lens unit when
adjusting panning, tilting, or azimuth.
• The video output to the BNC will be interrupted while
an LCD monitor is connected to the monitor output
jack.
1. Connect an LCD monitor to the video jack.
2. Pan/tilt/azimuth adjustment
• Loosen the two screws locking the pan and tilt
tables.
• Pan and tilt the table to aim the camera at what you
need to watch.
• Turn the azimuth adjuster to obtain a level image.
• Tighten the two screws after adjustment.
Pan lock screw
Panning table
Variable angles
plus or minus 75°
(max.)
Monitor
output jack
Azimuth adjuster
Tilting lock screw
Type of
coaxial cable
RG-59/U
(3C-2V)
Recommended
maximum
cable length
(m)
(ft)
RG-6/U
(5C-2V)
RG-11/U
(7C-2V)
RG-15/U
(10C-2V)
250 500 600 800
825 1650 1 980 2 640