Panasonic WV-NW474SE Security Camera User Manual


 
-7-
MAJOR OPERATING CONTROLS & THEIR FUNCTIONS
A
B
L
E
F
T
R
IG
H
T
U
P
D
O
W
N
SET
LINK
LED
OFF
LED
ON
RCV
A
B
L
EFT
R
IG
HT
U
P
D
O
W
N
SET
LINK
LED
OFF
LED
ON
RCV
u
i
o
!0
!1
!2
!3
!4
!5
!6
!7
!9
!8
t
r
q
y
w
Transport Protection
Screws (Red)
e
q Tilting lock screw
Fixes the tilting position.
w Panning table
Adjusts the panning angle of the camera.
e Azimuth adjuster
Adjusts the azimuth angle to level the image.
r Pan lock screw
Fixes the panning position.
t Zoom lock lever
Fixes the zoom position after adjustment.
y Focus lock lever
Fixes the focus position after adjustment.
u Optional heater connector
When an optional heater unit is installed in the cam-
era, the harness exiting from the unit will be con-
nected to this.
i Reset button (A)
Holding down the Up and Down buttons simultane-
ous for 15 seconds in the power-on state will reset
the network setup parameters.
Note: Never press both reset buttons A and B at the
same time.
o Reset button (B)
Holding down the Up and Down buttons simultane-
ously for 15 seconds in the power-on state will reset
the HTML files and alarm mail setup.
!0 LED switch
ON:
Enables the LINK and RCV LEDs to
indicate the communication status.
OFF: Disables the status indication.
Note: Normally set the switch to OFF. Set it
to ON only when you check the communication
status. Failure to do so may cause disturbance to
the camera image, or light leakage to the outside
of the camera in dark places.
!1 Link indicator (LINK)
Lights up when establishing communications via the
network if the LED switch is set to ON.
!2 Receive indicator (RCV)
Lights up when receiving data via the network if the
LED switch is set to ON.
!3 Left button (Left)
Moves the cursor to the left, selects the mode, and
adjusts some levels.
!4 Right button (Right)
Moves the cursor to the right, selects the mode, and
adjusts some levels.
!5 Up button (Up)
Moves the cursor upward and selects items in the
menu setup.
!6 Down button (Down)
Moves the cursor downward and selects items in the
menu setup.
OFF
ON