Filter
Top Products
-24-
• Editing the Setup Menu
Important Notices:
• When SET UP DISABLE appears in the bottom line
of the SET UP menu, you cannot change the cur-
rently active settings. This is to prevent accidental
changing of the settings.
• Set the RS485 menu previously. (See page 25.)
• When the setup menu is closed after changing the
parameters in the menu, the new values are saved
in the EEPROM (Electric Erasable and
Programmable Read Only Memory). These values
remain valid until new values are saved, even if the
power of the camera is off.
To edit the SET UP menu (change settings), press
J
and K or L and M to move the cursor to SET UP
DISABLE in the bottom line.
Press
I. SET UP DISABLE changes to SET UP
ENABLE. Move the cursor to END, then to the item(s)
you want to change. Move the cursor to CAMERA or
RS485, then press
I.
Refer to the following sections for a detailed description
of menu items. If you decide not to make any changes
after checking the current settings, move the cursor to
RET in the bottom line, and press
I to return to the
SET UP menu. Then move the cursor to END in the SET
UP menu, and press
I to close the setup menu.
** CAM SET UP **
CAMERA ID OFF
ALC/ELC ALC
SHUTTER OFF
AGC ON (DNR-H)
SENS UP OFF
SYNC INT
WHITE BAL ATW1
MOTION DET OFF
LENS DRIVE DC
RET
↵↵
↵
* RS485 SET UP *
UNIT NUMBER 1
BAUD RATE 19200
DATA BIT 8
PARITY CHECK NONE
STOP BIT 1
XON/XOFF NOT USE
WAIT TIME OFF
ALARM DATA AUTO2
DELAY TIME OFF
RET
↵
** SET UP **
CAMERA
RS485
END SET UP DISABLE
↵
↵
** SET UP **
CAMERA
RS485
END SET UP ENABLE
↵
↵