Filter
Top Products
-41-
Note: ATW1 and ATW2 do not appear for WHITE
BAL on the system controller setup menu.
• Automatic White Balance Control Mode (AWC)
In this mode, accurate white balance is obtained
within a colour temperature range of approximately
2 300 - 10 000K.
1. Move the cursor to WHITE BAL and select AWC
→
PUSH SW.
2. Press
I to start the white balance setup. The
PUSH SW is highlighted to indicate that the white
balance is being set.
3. When the white balance setting is completed, the
PUSH SW returns to normal display.
Note: In case that the white balance is not set, the
PUSH SW is being highlighted.
4. When you want to adjust the white balance manual-
ly, press
M to select AWC and press I. The
AWC menu appears on the monitor. (When ATW is
selected, pressing
I displays the ATW menu.)
** CAM SET UP **
CAMERA ID OFF
ALC/ELC ALC
SHUTTER OFF
AGC ON(DNR-H)
SENS UP OFF
SYNC INT
WHITE BAL AWC
→
PUSH SW
MOTION DET OFF
LENS DRIVE DC
RET
↵↵
↵
** CAM SET UP **
CAMERA ID OFF
ALC/ELC ALC
SHUTTER OFF
AGC ON(DNR-H)
SENS UP OFF
SYNC INT
WHITE BAL AWC
→
PUSH SW
MOTION DET OFF
LENS DRIVE DC
RET
↵↵
↵
Highlighted
** CAM SET UP **
CAMERA ID OFF
ALC/ELC ALC
SHUTTER OFF
AGC ON(DNR-H)
SENS UP OFF
SYNC INT
WHITE BAL AWC
MOTION DET OFF
LENS DRIVE DC
RET
↵↵
↵
↵
** AWC **
R ....I....
- +
B ....I....
- +
MASK SET
RET END
↵