Panasonic WVCP304 Security Camera User Manual


  Open as PDF
of 28
 
16
CP310
CP310
CP300
AUTO: Similar to the basic functions of AUTO1, but does not change the IR filter.
Switches to black-and-white images when brightness (illuminance) around the
camera is lower than approx. 0.1 lx.
OFF (default): Displays color images.
Note:
•
CP310
CP310
CP300
When “AUTO1” or “AUTO2” is selected, it is recommended to set “AGC” to “ON”.
• Ifasubjectisalwaysmovingorthescreenisoccupiedwithauniformcolor,brightness
determination may not be performed successfully because the brightness is merely deter-
minedbyinformationfromtheCCDimagesensor.When"AUTO2"isselected,thewave
length of the light source shall be 800 nm or longer.
• WV-CP300andWV-CP304cannotsettheswitchingbrightness(illuminance)levelofcolor
images and black-and-white images.
• Toobtaincolorimages,asufficientlevelofilluminance(approx.30lxormore)isrequired.
Step 2
Pressthe[SET]button.
→ The "D&N (IR)" screen appears.
Step 3
Movethecursorto"LEVEL"andselectabrightnesslevelatwhichswitchingbetweencolorand
black-and-white images is performed from the following.
LOW: Switches from color to black-and-white images when the ambient brightness (illumi-
nance) of the camera is less than 0.1 lx.
HIGH (default): Switches from color to black-and-white images when the ambient brightness
(illuminance) of the camera is less than 0.2 lx.
Note:
• Theswitchingilluminancelevelvarieswithsubjects,lightsources,andlenses.
• TheswitchingilluminancelevelvariesinaccordancewithAGCsetting.(
page 12)
• Theswitchingilluminancesdescribedabovearereferencevalues.Theswitchingillumi-
nanceshallbedecidedbasedontheactualinstallationenvironment.
• Theremayberepeatedswitchingbetweencolorandblack-and-white images depending
onthesettingandenvironment.
Step 4
Movethecursorto"DURATIONTIME"andselectatimeforswitchingbetweencolorand
black-and-white images from the following.
2S-10S(default)-30S-60S
(S)
(L)
Step 5
Movethecursorto"BURST(BW)",anddecidewhetherornottoprovideaburstsignaloutput
in the black-and-white mode.
ON (default): Providesaburstsignaloutput.
OFF: Doesnotprovideanyburstsignaloutput.
CP310
CP310
CP300
CP310
CP310
CP300
CP310
CP310
CP300
CP310
CP310
CP300
 previous next