Filter
Top Products
19
n Turn on the power.
WV-CP500
The included power cord is connected to this power connector.
Connect between the power connector on the rear side of the camera and a plug socket
with the supplied power cord.
POWER
ALARM OUT
ALARM IN
GND
VIDEO OUT
120V ~ 60Hz
120 V AC 60 Hz
Power cord (accessory)
WV-CP504
Important:
• Thepowersupplyof24VAC/12VDCshall
be insulated against 120 V AC.
• Thepowersupplyisautomaticallyselected
either 24 V AC or 12 V DC. No setting is
required with this camera.
q Loosen the screw of the power cord plug
(accessory).
w Connect the power supply (option) of 24 V
AC or 12 V DC to the power cord plug.
Strip the end of the wire by 3 mm to 7 mm
{1/8" to 1/4"}, and twist the stripped part of
the wire sufficiently to avoid short circuit.
• Specificationofcable(wire)
AWG #16 - #28, Single core, twisted
* Check whether the stripped part of the
wire is not exposed and is securely con-
nected.
<Ratings>
AC 24 V DC 12 V
2-N @ (GND)
GND NC
1-L !
e Tighten the screw of the power cord plug.
r Connect the power cord plug to the AC/DC
power terminal on the rear side of the camera.
* Make sure that the power cord plug is inserted fully into the AC/DC power supply terminal.
ALARM OUT
ALARM IN
POWER
VIDEO OUT
24V IN~
1-L
12V IN
NC
2-N
GND
(UP)
(LEFT)
(RIGHT)
(DOWN)
(SET)
NEAR
FAR
BF/MENU
GND
To 24 V AC/12 V DC
power supply
C B A
Power cord plug
(accessory)
Stripped
Approx. 3 mm - 7 mm
{1/8" to 1/4"}