Panasonic WV-SF130 Series Security Camera User Manual


 
Default: 443
The following port numbers are unavailable since they are already in use.
20, 21, 23, 25, 42, 53, 67, 68, 69, 80, 110, 123, 161, 162, 554, 995, 10669, 10670, 59000-61000
Note
The camera will restart after the connection setting is changed.
When using the self-signed certificate:
If the camera is accessed using the HTTPS protocol for the first time, the warning window will be
displayed. In this case, follow the instructions of the wizard to install the self-signed (security) certificate.
(®page 179)
When using the server certificate:
In advance, install the root certificate and intermediate certificate on the browser in use. Follow the
instructions of CA for how to obtain and install these certificates.
When the camera is accessed using the HTTPS protocol, the refresh interval and frame rate of images
may be lower.
When the camera is accessed using the HTTPS protocol, it may take time to display images.
When the camera is accessed using the HTTPS protocol, the images may be distorted or audio may
be interrupted.
The maximum number of concurrent access user varies depending on the maximum image size and
transmission format.
[FTP access to camera]
Select “Allow” or “Forbid” to determine whether to allow or forbid the FTP access to camera.
Default: Forbid
[Bandwidth control(bit rate)]
Select the total bit rate for data transmission from the following.
Unlimited/ 64kbps/ 128kbps/ 256kbps/ 384kbps/ 512kbps/ 768kbps/ 1024kbps/ 2048kbps/ 4096kbps/
8192kbps
Default: Unlimited
Note
When selecting “64kbps”, select “Off” for “Audio transmission/reception” on the “Audio” tab.
(®page 130)
Select “128kbps” or a faster rate to carry out the live transmission of JPEG images and the FTP periodic
image transmission simultaneously.
When “Bandwidth control(bit rate)” is set low, taking a picture using the snap shot button may not
function depending on the use environment. In this case, select “QVGA” for “Image capture size” of
“JPEG” on the [JPEG/H.264] (or [JPEG/MPEG-4]) tab or set “Image quality setting” of “JPEG” lower.
[Easy IP Setup accommodate period]
Select “20min” or “Unlimited” to determine how long the network setting operation using the Panasonic “IP
Setting Software” can be allowed since the camera starts up.
20min: The camera and the network setting operation using the Panasonic “IP Setting Software” are
allowed for 20 minutes since the camera starts up.
Unlimited: The camera and the network setting operation using the Panasonic “IP Setting Software” are
allowed without time limitation.
Default: 20min
Note
Refer to the network administrator for the addresses of each server.
Operating Instructions 169
17 Configuring the network settings [Network]