Filter
Top Products
10
10
11
Action at an alarm occurrence
The alarm action (camera action at an alarm occurrence) will be performed when the following alarms occur.
Alarm type
VMDalarm: WhenmotionisdetectedinthesetVMDarea,thealarmactionwillbeperformed.
* VMD stands for "Video Motion Detection".
Commandalarm: WhenaPanasonicalarmprotocolisreceivedfromtheconnecteddeviceviaanetwork,the
alarm action will be performed.
Action at an alarm occurrence
Display the alarm occurrence indication button on the "Live" page. (☞ Page 8)
The alarm occurrence indication button will be displayed on the "Live" page at an alarm occurrence.
Important:
•When"Polling(30sec)"isselectedfor"Alarmstatusupdatemode"(☞ page 18), the alarm occurrence indication
button will be refreshed in 30 second intervals. For this reason, it may take a maximum of 30 seconds until the
alarm occurrence indication button is displayed on the "Live" page at an alarm occurrence.
Transmit an image onto a server automatically
An alarm image can be transmitted at an alarm occurrence to the server designated in advance. The settings
required to transmit an alarm image to a server can be configured in the "Alarm image" section on the [Alarm] tab of
the "Alarm" page (☞ page 32) and the [FTP] tab of the "Server" page (☞ page 41).
Notify of alarm occurrences by e-mail
Alarm mail (alarm occurrence notification) can be sent at an alarm occurrence to the e-mail addresses registered in
advance. Up to 4 addresses can be registered as recipients of the alarm mail. An alarm image (still picture) can be
sent with the alarm mail as an attached file. The settings for alarm mail can be configured in the "Mail notification"
section on the [Notification] tab of the "Alarm" page (☞ page 36) and the [Mail] tab of the "Server" page (☞ page
41).
Notify of alarm occurrences to the designated IP addresses (Panasonic alarm protocol notification)
This function is available only when a Panasonic device, such as the network disk recorder, is connected to the
system.When"On"isselectedfor"Panasonicalarmprotocolnotification",theconnectedPanasonicdevicewillbe
notified that the camera is in the alarm state. The settings for Panasonic alarm protocol can be configured in the
Panasonic alarm protocol section of the [Notification] tab of the "Alarm" page. (☞ Page 37)